How-to use Banana Loca®

Cut off the tip of the banana about half an inch from the top.

Straighten the banana by putting the cut tip end into the holder, gently straighten the banana against the holder with one hand.

Insert the corer into the holder, do not twist or cover the hole while inserting. Once fully inserted, twist the handle, cover the hole with your thumb and pull out the corer.

Fill hopper with 3 tablespoons of filling per banana. Push down on the handle until you see the filling at the very tip of the nozzle.

Insert the nozzle into the banana while holding it gently. Push down on the handle and let the filling push the banana out.

Insert the plunger into the corer to push out the core

Insert the plunger through the nozzle to remove excess filling

Brush all Banana Loca® parts with warm soapy water then rinse and let air dry.

Match nozzle notch with top gap on white screw section of hopper, join together. Place yellow cap over nozzle and screw clockwise until firmly against brown body of hopper.